升降貨梯有很多配件組成，其中軸銷是固定升降平臺使用最多的部件，也是比較容易損壞的部件。大家在使用時需要二至三年更換一次，大家在更換時需要注意哪些問題呢？
1、升降貨梯http://m.zjfutures.cn/如果需要更換的軸銷超過50%時，應對所有軸銷進行檢查，磨損超過90%的軸銷必須更換。
If the cargo lifter shaft pin needs to be replaced more than 50%, to address all pivot pin checks wear more than 90% of the pivot pin must be replaced.
2、升降貨梯更換軸銷時，應使用行車或吊鏈把臺面拆下，并平穩放置在安全影響工作的地方，應檢查耐磨套的磨損狀況，如果磨損超過了80%，也應該同時更換。耐磨套更換時，應由正規生產廠家更換，耐磨套的定位的精準程度，這樣直接影響著升降平臺的偏擺量。
When cargo lifter replacement axle pin, should use the road or hanging chain remove the tops and put in place security implications steady work, check the wear sleeve wear conditions, if wear exceeds 80%, it should also be replaced.When the wear sleeve replacement, regular manufacturer shall replace the extent of wear sleeve accurate positioning, so a direct impact on the amount of deflection of the lifting platform.
3、升降貨梯http://m.zjfutures.cn/軸銷更換完成后，應重新進行技術檢驗，磨損嚴重的軸銷部位，應通知廠家，由廠家進行技術分析，找出磨損的快的原因，如果是廠家的技術原因，應該由廠家自行解決.
Lift freight elevator shaft pin replacement is completed, it should be re-tested technology, badly worn shaft pin parts, should notify the manufacturer, the technical analysis by the manufacturer to find out the cause of rapid wear and,if the manufacturer for technical reasons, it should be by the manufacturers themselves resolved.
請長按保存二維碼后點擊確定按鈕，進入微信掃一掃界面,點擊右上角‘相冊’選擇我們的二維碼,再點擊右上角‘完成’識別添加。
(為防止瀏覽器錯誤識別，請勿直接在瀏覽器中識別二維碼)
